Welcome to Certabo forum

Both posts in italian and in english are accepted on the forum to help everybody to provide contribution irrespective to geographical location. Object of the forum is to provide technical information on various items and help developer and users to personalise software for Certabo chessboards. User explicitly accepts the conditions of use of this forum here reported.

A brief introduction of user is always appreciated in section Welcome to….

Benvenuti nel forum di Certabo

Sul forum possono essere postati articoli sia in lingua italiana che inglese per permettere a tutti di dare il proprio contributo da diversi luoghi geografici. Il forum ha come scopo fornire informazioni tecniche in generale e aiutare gli sviluppatori ed utenti a personalizzare software per le scacchiere Certabo. L’utente accetta esplicitamente le condizioni del presente forum consultabili qui.

Un breve saluto del nuovo utente è sempre gradito nella sezione Benvenuti a….

Please or Register to create posts and topics.

Occasional loss/ghosting on specific squares

Gerald@gerald-bonne
10 Posts
#1 · August 31, 2020, 2:01 pm

Hi,

Is it possible or normal, that regularly a piece very briefly vanishes from the board in the PC application although we did not touch the actual piece?

From the starting position a bishop regularly flashes away and back, also sometimes causing its led to light up. It is present most of the time on screen though.

As long as the software handles that I see no issue (I had no problem in a game vs engine using Certabo 3.5), except that in the mobile app (especially Aart Bik's Chess for Android) it causes the game to glitch sometimes.

I use the electronic chess pieces. I tested with the RFID chips, also swapping "pieces" (chips) out, the issue is with the square, not the piece.

Kind regards,
G.

Click for thumbs down.0Click for thumbs up.0
Pietro@pietro-mandurino
352 Posts
#2 · August 31, 2020, 4:13 pm

Hello Gerald

Thank you for your post normally you can see flashing piece if it is may be too offset from center, then the leds will flash to advice its not there.

Anyhow if the piece is centered and there it shall show in the software, ok if it you swap the piece and also make the same beahviour with chips there yes maybe something iusse with square as it must show pieces correctly.

I will pm you to deep the issue

All the best

Pietro

Click for thumbs down.0Click for thumbs up.0